Helium leak testing
Non-destructive leak checks on welded parts, run in-house on a Varian 936-70SP helium leak detector.
Helium leak testing for electron beam welded parts
A helium leak test checks that a weld is hermetically sealed. Helium works well as the tracer gas because it's small and inert, and a mass-spectrometer leak detector can pick it up at extremely low leak rates. Our Varian 936-70SP gives leak rate readings to 1 × 10-8 cc/sec.
The test is non-destructive, so the part can still be used afterward. We run it in-house right after welding.
- 1 × 10-8 cc/sec leak rate readings
- 936-70SP Varian leak detector
- In-house Run after welding
How a welded part is leak tested
Finish the weld
The part is electron beam welded first, so the test checks the finished weld.
Fit the fixture and O-ring
We use the fixture and O-ring that the part needs, so the welded area can be sealed.
Run the test
Once the welded area is sealed, we run the helium leak test on the Varian 936-70SP.
Why test welds with helium
Non-destructive
Nothing is cut or damaged, so the part can ship after testing.
Detection sensitivity
Leak rate readings to 1 × 10-8 cc/sec on the Varian 936-70SP.
Same shop as the weld
We weld and leak test in the same shop, so parts don't ship out to a second vendor.
Helium leak testing questions
Is helium leak testing destructive?
No. Nothing is cut or altered, so the part can be used afterward.
How sensitive is the test?
Our Varian 936-70SP reads leak rates down to 1 × 10-8 cc/sec.
Why use helium?
Helium is a small, inert gas, which makes it a good tracer. A mass-spectrometer leak detector picks it up at extremely low leak rates.
Can I add leak testing to an EB welding order?
Yes. Mention it when you send your print, and include any leak rate your drawing specifies.
Send us your print
Quotes are typically returned within 1 day. Include the material, quantity, and the date you need the parts.
PDF · DWG · DXF · STEP · JPG · PNG
- Phone (713) 690-2326
- Email info@beamweld.com



